TECHNICAL DATA SHEET & PROCESS GUIDE

 Restores original appearance to body panels, under hood, chassis and wheels.

• Suitable for use over existing paint surfaces
• Replicates factory look on aluminum and plastic trim panels
• High gloss, satin, matte or metallic finish
• Excellent pigment density, essentially single coat coverage
• Apply direct to TPO, EDPM, and polypropylene without adhesion promotor

TECHNICAL DATA & APPLICATION GUIDE

SUBSTRATES

• Prepared OEM painted surfaces
• Lightly abraded E coat
• TPO, EDPM, polypropylene

TOOLS REQUIRED

• System 20 UP2012/UP2022 Solvent Based Degreaser or UP2002 Water Based Degreaser
• 400-600 Grit Sandpaper

SUBSTRATE PREPERATION

• For best results, ensure the surface is thoroughly cleaned, degreased, dried and dust free.
• Sand primed surfaces wet or dry with 400-600 grit sandpaper, degrease and dry.

MIXING

• Share aerosol can for at least 2 minutes before use.

COATS

• 1-2 coats at a distance of approximately 6-10” from the surface,
• Build/mMIL : 0.60 per coat
• Coverage: approximately 48.4 square feet

FLASH-OFF / Min @ 68° F

• Between coats, 3-5 minutes

DRYING TIMES

• Dust free @ 68° F/ min : 20-30 minutes

SHELF LIFE

• 2 years subject to proper storage conditions
• Aerosol cans should be stored for two hours at room temperature before use. For long term storage, keep in a dry well ventilated area and away from direct sunlight and frost. To clear the nozzle and maximize the lifespan of your aerosol, always invert the can and spray upside down for a few seconds after each use. Should the nozzle become blocked, remove it from the can and soak it in gentle thinners.
• Recommended Storage Temperature 41°F - 77°F
• Recommended Application Temperature 68°F