TECHNICAL DATA SHEET & PROCESS GUIDE

High build lacquer primer aerosol that fill uneven surfaces prior to topcoating. Ideal for spot repairs on fully cured paint, polyester body fillers, GRP and properly prepared steel, aluminum, and galvanized panels.

• Produces a similar film thickness to spray gun applied primers
• Saves time and materials – no need to mix paint or clean spray equipment and minimizes masking
• Chromate free and easy to sand

TECHNICAL DATA & APPLICATION GUIDE

SUBSTRATES

• Direct to metal
• SMC
• Lightly abraded E-coat
• Prepared OEM paint surfaces
• Fiberglass

TOOLS REQUIRED

• System 20 UP2012/UP2022 Solvent Based Degreaser or UP2002 Water Based Degreaser
• 220-400 Grit Sandpaper

SUBSTRATE PREPERATION

• For best results, ensure the surface is thoroughly cleaned, degreased, dried and dust free.
• Abrade primed surfaces wet or dry with 180-220 grit sandpaper, degrease and dry.
• For best results on bare metal, galvanized steel & aluminum surfaces, apply 1-2 light even coats of ACID#8, allowing 30 minutes drying time before priming.

MIXING

• Share aerosol can for at least 2 minutes before use.

COATS

• 1-2 coats at a distance of approximately 10” from the surface
• Build/mMIL : 1.8 MIL
• Coverage: approximately 21.5 square feet

FLASH-OFF / Min @ 68° F

• Between coats, 5-10 minutes

DRYING TIMES

• Dust free @ 68° F/ min : 60 minutes

SHELF LIFE

• 2 years subject to proper storage conditions
• Aerosol cans should be stored for two hours at room temperature before use. For long term storage, keep in a dry well ventilated area and away from direct sunlight and frost. To clear the nozzle and maximize the lifespan of your aerosol, always invert the can and spray upside down for a few seconds after each use. Should the nozzle become blocked, remove it from the can and soak it in gentle thinners.
• Recommended Storage Temperature 41°F - 77°F
• Recommended Application Temperature 68°F