TECHNICAL DATA SHEET & PROCESS GUIDE

Promotes paint adhesion to most automotive surfaces, like plastics, aluminum, galvanized metal, zinc, painted surfaces, fiberglass and even body fillers. Replaces the need to abrade surfaces in hard-to-sand areas, like under hoods and deck lids.

• Excellent adhesion characteristics
• Sprays flat
• Can be topcoated with most water or solvent based systems
• Helps to prevent lifting in hard to sand areas

TECHNICAL DATA & APPLICATION GUIDE

SUBSTRATES

• Direct to metal
• SMC
• Aluminum
• Lightly abraded E-coat
• Prepared OEM paint surfaces
• Galvanized coated steels
• Fiberglass

TOOLS REQUIRED

• System 20 UP2012/UP2022 Solvent Based Degreaser or UP2002 Water Based Degreaser
• 220-400 Grit Sandpaper

SUBSTRATE PREPERATION

• For best results, ensure the surface is thoroughly cleaned, degreased, dried and dust free.
• Thoroughly clean the area to be coated with detergent and water and allow to dry completely OR thoroughly clean and degrease surfaces with precleaner or panel wipe by applying it with a clean wiper and wiping off with a second dry clean wiper.
• Tack cloths can be used to remove loose dust from the panel immediately before application.
  
  
  

MIXING

• Share aerosol can for at least 2 minutes before use.

COATS

• 1-2 coats at a distance of approximately 10” from the surface
• Build/mMIL : 0.08 MIL
• Coverage: approximately 32.3 square feet

FLASH-OFF / Min @ 68° F

• Between coats, 10 minutes

DRYING TIMES

• Dust free @ 68° F/ min : 10 minutes
• Overcoat time 68° F/ min : 20 minutes
• Allow to dry 20 minutes before applying any solvent based primer, color or clear.
• Drying time is dependent upon film thickness, humidity and temperature.

SHELF LIFE

• 2 years subject to proper storage conditions
• Aerosol cans should be stored for two hours at room temperature before use. For long term storage, keep in a dry well ventilated area and away from direct sunlight and frost. To clear the nozzle and maximize the lifespan of your aerosol, always invert the can and spray upside down for a few seconds after each use. Should the nozzle become blocked, remove it from the can and soak it in gentle thinners.
• Recommended Storage Temperature 41°F - 77°F
• Recommended Application Temperature 68°F