TECHNICAL DATA SHEET & PROCESS GUIDE

A high adhesion, super conductive primer offering excellent rust and corrosion protection when applied to panels prior to Resistance Spot, MIG and TIG welding.

• High concentration of zinc or copper in the dry film
• Superior conductivity
• Clog free nozzle
• Fast drying - speeds up the welding process
  
  

TECHNICAL DATA & APPLICATION GUIDE

SUBSTRATES

• Direct to metal
• Aluminum
• Galvanized coated steels

TOOLS REQUIRED

• System 20 UP2012/UP2022 Solvent Based Degreaser or UP2002 Water Based Degreaser
• 180-220 Grit Sandpaper

SUBSTRATE PREPERATION

• For best results, ensure the surface is thoroughly cleaned, degreased, dried and dust free.
• Abrade primed surfaces with 180-220 grit sandpaper, degrease and dry.

MIXING

• Share aerosol can for at least 2 minutes before use.

COATS

• 1-2 coats at a distance of approximately 10” in from the surface
• Build/mMIL : 0.4 MIL
• Coverage: approximately 53.8 square feet

FLASH-OFF / Min @ 68° F

• Between coats, 5-10 minutes

DRYING TIMES

• Weldable @ 68° F : 10-20 Minutes

SHELF LIFE

• 2 years subject to proper storage conditions
• Aerosol cans should be stored for two hours at room temperature before use. For long term storage, keep in a dry well ventilated area and away from direct sunlight and frost. To clear the nozzle and maximize the lifespan of your aerosol, always invert the can and spray upside down for a few seconds after each use. Should the nozzle become blocked, remove it from the can and soak it in gentle thinners.
• Recommended Storage Temperature 41°F - 77°F
• Recommended Application Temperature 68°F